Tension Lock 2 Drawer Removal Instructions

System-specific instructions are located on the back of the product.  The general procedure for disengaging the system is as follows:

• Open the drawer requiring removal
• Reach behind the drawer back panel to locate the gated hook and interlock cord
• Open the gate and remove the cord from the hook

System-specific instructions are located on the back of the product.  The general procedure for reengaging the system is as follows:

• Check that any drawers removed for maintenance are properly reengaged in their slides.
• Open the drawer requiring re-engagement
• Reach behind the drawer back panel to locate interlock cord.  If you feel multiple cords, select the one nearest the center of the product
• Locate the gated hook and open it
• Move the cord into the hook and release the gate

Always test your Tension Lock 2 system after reengaging it:

• Locate a drawer controlled by the interlock that was temporarily disengaged.
• Fully open selected drawer and leave it open.
• Open another drawer in the same column of drawers.
• If the interlock is properly engaged opening the closed drawer will cause the open drawer to close.

• Following the instructions above, remove the top drawer and check for snags or obstructions in the interlock cord.
• Replace the top drawer, reengage the interlock, and remove the next drawer to check for snags or obstructions.
• Continue until the issue is identified and resolved.
• If you remove multiple drawers, make sure to number them.  Most drawers are custom-fitted to the slot in which they are installed.
• Always reengage and test the interlock using the instructions above after disengaging it.
• Please contact us for further assistance.